Telephone Number - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Telephone Number

Telephone Number
Use this procedure to assign a string of up to 12 digits to each PRI channel.
This string must match the number sent by the network (that is, the number
provided by the PRI service provider) to indicate the number dialed by an
outside caller. The system uses this number to route the call to the correct
destination, which means that the number assigned to each channel in the
same B-channel group must be unique. Note also that the number cannot be
the same as the associated test telephone number.
Summary: Telephone Number
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
No digits
Up to 12 digits (any combination of 0 to 9)
No
No
LinesTrunks PRI
Drop Dial telephone no.
Enter
Exit
[F4] [F6] [F1]
Type telephone no.
PhoneNumber
Enter
Type trunk no. [F10]
[F10] [F5] [F5]
Dial trunk no.
Exit
[Alt] + [P]
PRI Facilities 9-3