Configuring Ip Addresses And Community Strings; Discover Setup Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Setting Up the Application
Figure 25: Discover Setup dialog box
2. Specify the IP addresses you want to discover through out-of-band discovery.
Note:
address in the Discover Setup dialog box's Out-of-Band tab. If you do not configure
the application to discover the devices directly, the connections and attached devices
may not display correctly.
3. Select IP addresses from the Available Addresses table and add them to the
4. Click OK.
5. Turn discovery on or off by choosing Discover > On or Discover > Off.

Configuring IP Addresses and Community Strings

You can configure IP addresses and community strings through which the
application can perform discovery and communication functions.
70
You can add, change, and remove IP addresses as necessary. See
"Configuring IP Addresses and Community
instructions.
To correctly discover all SAN products, you must specify each product's IP
Selected Individual Addresses table by clicking the
Strings" on page 70 for
buttons.
HA-Fabric Manager User Guide