Creating A Zone Set; Adding Zones To Zone Sets - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring Zoning
9. Click OK.
Note:
you click Cancel or the close button (X), only zoning changes made to the active zone
set is saved. Changes to the active zone set are saved because they have been
activated and saved on the switch.

Creating a Zone Set

1. Choose Configure > Zoning. The Zoning dialog box displays, as shown in
2. Choose a fabric from the Fabric drop-down list. This sets the fabric to target
3. Click the Zone Library tab.
4. Click New Set to create a new zone set.
5. Rename the zone set. See
6. Press Enter.
7. Click OK.

Adding Zones to Zone Sets

1. Choose Configure > Zoning. The Zoning dialog box displays, as shown in
2. Choose a fabric from the Fabric drop-down list. This sets the fabric to target
3. Click the Zone Library tab.
4. Choose zone set(s) to which you want to add zones to from the Zone Sets list.
5. Click the
6. Repeat
7. To activate a zone set, choose the zone set and click Activate.
8. Click OK.
196
Library changes are not saved unless you click OK on the Zoning dialog box. If
Figure 101 on page 192.
all zoning actions.
naming conventions.
Figure 101 on page 192.
all zoning actions.
Press CTRL and click to select more than one zone set.
button to the right of the Zones area to add the selected zone(s)
to the zone set(s).
step 4 through
"Zoning Naming
step 5 for each zone you want to add to the zone set.
Conventions" on page 275 for
HA-Fabric Manager User Guide