Configuring Ip Parameters For Routing Switches; Configuring Ip Addresses; Configuring Arp Parameters - HP Procurve 2650 Management And Configuration Manual

IP Routing Features

Configuring IP Parameters for Routing Switches

Configuring IP Parameters for Routing
Switches
The following sections describe how to configure IP parameters. Some param-
eters can be configured globally while others can be configured on individual
VLAN interfaces. Some parameters can be configured globally and overridden
for individual VLAN interfaces.
N o t e
This section describes how to configure IP parameters for routing switches.
For IP configuration information when routing is not enabled, see chapter 7,
"Configuring IP Addressing".

Configuring IP Addresses

You can configure an IP address on the routing switch's VLAN interfaces.
Configuring IP addresses is described in detail in chapter 7, "Configuring IP
Addressing".

Configuring ARP Parameters

Address Resolution Protocol (ARP) is a standard IP protocol that enables an
IP routing switch to obtain the MAC address of another device's interface
when the routing switch knows the IP address of the interface. ARP is enabled
by default and cannot be disabled.
How ARP Works
A routing switch needs to know a destination's MAC address when forwarding
traffic, because the routing switch encapsulates the IP packet in a Layer 2
packet (MAC layer packet) and sends the Layer 2 packet to a MAC interface
on a device directly attached to the routing switch. The device can be the
packet's final destination or the next-hop router toward the destination.
The routing switch encapsulates IP packets in Layer 2 packets regardless of
whether the ultimate destination is locally attached or is multiple router hops
away. Since the routing switch's IP route table and IP forwarding cache
contain IP address information but not MAC address information, the routing
switch cannot forward IP packets based solely on the information in the route
15-7