Adding Members To A Zone - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

7. Click OK to save your changes and close the Add Zone Member dialog box.
8. Click OK.
Note:
you click Cancel or the close button (X), only zoning changes made to the active zone
set is saved. Changes to the active zone set are saved because they have been
activated and saved on the switch.

Adding Members to a Zone

1. Choose Configure > Zoning. The Zoning dialog box displays, as shown in
2. Choose a fabric from the Fabric drop-down list. This sets the fabric to target
3. Click the Zone Library tab.
4. Choose the zone(s) to which you want to add members to from the Zones list.
5. Choose an option from the Zoning Method drop-down list.
6. Choose the member(s) to add to the zone(s) from the Potential Zone
7. Click the
8. Repeat steps 4 through 7 for each member you want to add to the zone.
HA-Fabric Manager User Guide
— To add a zone member by specifying its domain and port, choose
Domain/Port and enter the domain and port in the appropriate fields. If
you add an invalid domain/port value and activate the zone set, the
application may initially indicate that the zone has been configured
properly. However, a zoning mismatch message displays on the Zoning
dialog box after the next discovery pass.
— To add a zone member by its world-wide name, choose WWN and enter
the WWN in the field. If you add an invalid WWN address and activate
the zone set, the application may initially indicate that the zone has been
configured properly. However, a zoning mismatch message displays on
the Zoning dialog box after the next discovery pass.
Library changes are not saved unless you click OK on the Zoning dialog box. If
Figure 101 on page 192.
all zoning actions.
Press CTRL and click to select more than one zone.
Members list. Press CTRL and click to select more than one member. To add
all ports on a device, select the device.
button to the right of the Potential Zone Members list to add the
selected member(s) to the zone(s).
Configuring Zoning
195