Specifying A Rule's Actions; Specifying An E-Mail Action - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Optional Features
13. Choose an action from the Actions list at the bottom left of the dialog box.
14. Enter the required information in the Value column for each listed parameter.
15. Click Add. The action you configured displays in the Actions area in the top
16. Repeat
17. Use the buttons to the right of the Actions area to move the action phrases up
18. Click OK.

Specifying a Rule's Actions

After specifying a rule's triggers, you can add actions that the application
performs when trigger conditions are met.

Specifying an E-mail Action

You can configure the application to send an e-mail message when the specified
trigger is fired.
Note:
Triggers" on page 128 for instructions.
1. Click the Event Management tab on the main window. The Event
2. Click New. The Add Rule dialog box displays, as shown in
3. Choose E-mail from the Actions list at the bottom left side of the dialog box.
138
For help with adding specific actions, see
Overview" on page 128.
half of the dialog box.
step 14 through
or down.
— Click Delete to remove selected rows from the table.
— Click the up and down arrows to move selected actions up and down to
change the order in which the actions are started.
Before specifying an action, you should specify the rule's triggers. See
Management tab displays, as shown in
page 134.
The E-mail information displays, as shown in
"Event Management Component
step 15 to add more actions.
Figure 69 on page 133.
Figure 70
Figure 73.
HA-Fabric Manager User Guide
"About
on