HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 32

Introduction and General Information
Note:
director. Only monitoring switch operations, logging events, and implementing
configuration changes are interrupted.
If the public LAN IP address of the HAFM server is ever changed, this file must
be edited again to reflect the new IP address.
Remote workstations are not supported on the secondary adapter, and must
always connect to the public adapter as shown in
For details on configuring remote workstations, see
Workstations" on page 251.
32
If you use a private LAN IP address, i.e. 10.x.x.x, this causes this LAN to be
designated as the private LAN. You must also have the public LAN
connection active when the HAFM server is booting up, or else the HAFM
application will interpret this as a single LAN connection configuration, and
the 10.x.x.x LAN will be designated as the LAN for remote client sessions.
You can configure a specified Ethernet interface on the HAFM server to be
the public LAN (to listen for remote client connections). To configure this
feature, you must manually edit a file on the HAFM server to explicitly
specify which IP address HAFM should use as the public LAN.
Perform the following to configure an Ethernet interface:
— Open the config.properties file in directory C:\Program
Files\HAFM\, and add the following line:
ServerRmiIpAddress=x.x.x.x
where x.x.x.x is the IP address assigned to one of the Ethernet LAN
adapters which is to be used as the public LAN. This entry is case
sensitive and must be made exactly as shown. Once this line has been
added, the HAFM server must be rebooted.
This does not impact the Fibre Channel operations of any edge switch or
Figure 2.
"Configuring Remote
HA-Fabric Manager User Guide