Novell NETWARE 6-DOCUMENTATION Manual page 1900

40
Filter Configuration
8
Modify the filter list.
Select a filter from the list and press Enter to modify the filter or Del to
remove it. Press Ins to add a new filter.
If you are modifying an existing filter or adding a new filter, modify the
following parameters from the Define Filter menu:
Source Interface Type —Press Enter and select Interface or
Interface Group as the incoming IPX packet source.
Source Interface —Press Enter and select the source from the list of
network interfaces or interface groups.
If you specified Interface as the Source Interface Type , select a
specific interface on which you want to filter the service. You can
select a LAN interface, a WAN interface, the internal network, or all
interfaces. The default is All Interfaces .
If you specified Interface Group as the Source Interface Type ,
select the specific interface group on which you want to filter the
service.
Source Circuit —If the source is a WAN interface, press Enter to
modify the following optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, or ATM)—The name of the
remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
NOTE:
If the optional fields are left blank, the filter will match all WAN calls
on the interface. If authentication is not enabled and the optional fields are
specified, the filter will not work.
Destination Interface Type —Press Enter and select Interface or
Interface Group as the IPX packet destination.