Changing Cast Properties; Viewing And Setting Cast Member Properties - MACROMEDIA DIRECTOR MX-USING DIRECTOR MX Use Manual

To make your preference settings the default settings, click Save as Default.
12
When you finish selecting your preferences, click OK.
13

Changing Cast properties

You use the Property inspector to change the name of a Cast and to define how its cast members
are loaded into memory.
To change Cast window properties:
With the Cast window as the active window, open the Property inspector and click the
1
Cast tab.
To change the name of the current cast, enter the new name in the Name text box.
2
Select one of the following Preload options to define how cast members are loaded into
3
memory when the movie runs:
When Needed
setting can slow down the movie while it plays, but it makes the movie begin playing sooner.
This setting is the best choice when controlling cast members loading with Lingo.
After Frame One
exits frame 1. This setting can ensure that the first frame appears as quickly as possible, and it
might be the best choice if the first frame of the movie is designed to remain onscreen for a
number of seconds.
Before Frame One
the movie take longer to start playing, but it provides the best playback performance if there is
enough memory to hold all cast members.

Viewing and setting cast member properties

You can display and set properties for individual cast members, or for multiple cast members at
once, even if the cast members are different types. In both cases, you use the Property inspector.
You can also set cast member properties by using Lingo (see "Setting cast member properties
using Lingo" on page 154).
142 Chapter 4
loads each cast member into memory when it is required by the movie. This
loads all cast members (except those required for frame 1) when the movie
loads all cast members before the movie plays frame 1. This setting makes