Removing and installing
34 21 222
rear brake calliper
e
Caution:
Refer to notes on the hazards involved in handling
brake fluid.
•
Remove wheel cover together with chain cover.
•
Press the brake calliper against the brake disc in
order to force the pistons back
2
1
•
Cut through cable tie (1).
•
[ABS] Remove fastener securing ABS sensor (4)
and remove ABS sensor.
•
Disconnect brake line (2) at brake calliper and
seal the line.
e
Caution:
Do not operate the brake with the wheel removed.
–
Remove rear wheel.
....................................................See Group 36
a
e
Caution:
Do not damage brake pads.
•
Remove brake calliper (3) from the rear swinging
fork.
34.8
3
4
E340080
•
Installation is the reverse of the removal proce-
dure.
L
Note:
Remove sealing rings for brake line.
e
Caution:
Top up brake fluid and bleed brake system.
Operate brake several times until brake pads are
correctly seated.
X
Tightening torque:
Brake line to brake calliper ........................... 18 Nm
ABS sensor to bracket ................................... 9 Nm
Quick-release axle ..................................... 100 Nm
Wheel cover bracket to swinging arm............. 9 Nm
Removing and installing rear
34 21 200
brake pads
See Group 00