BMW F 650 GS Repair Manual page 113

•
Check valve clearances.
•
Install chain tensioner and tighten threaded fas-
tener with sealing ring.
•
Remove all traces of the cylinder head cover
gasket and clean the sealing face with degreas-
ing agent. Also clean the groove and the seating
faces for the gasket.
•
Install valve cover with gasket.
•
Connect the oil lines to the engine block.
L
Note:
Install the oil return line with the tab at the bottom
and the oil feed line with the tab at the top.
•
Connect the oil lines to the cylinder head.
•
Take out locating pin, BMW No. 11 6 570, and
insert screw plug with sealing ring.
•
Install the spark plug.
•
Fit the filter element onto the oil-filter cover.
•
Coat the O-ring of the filter element lightly with
oil.
•
Check the O-ring of the oil-filter cover for dam-
age and replace if necessary.
•
Install the oil-filter cover complete with filter ele-
ment.
•
Install starter motor.
X
Tightening torque:
Camshaft bearing cap .................................. 10 Nm
Chain guide to bearing cap
(clean threads + Loctite 243) ........................ 10 Nm
Timing-chain tensioner to cylinder head ....... 40 Nm
Cylinder head cover to cylinder head ........... 10 Nm
Threaded plug in left side of engine block .... 25 Nm
Oil line to engine block ................................. 35 Nm
Oil line to cylinder head .................................. 8 Nm
Spark plug in cylinder head .......................... 20 Nm
Starter motor to clutch housing cover .......... 10 Nm
Oil filter cover ............................................... 10 Nm
11.55