BMW F 650 GS Repair Manual page 163

1
Removing and installing
18 00 020
exhaust system
Removing and installing
18 11 301
right-hand silencer
•
Remove number plate.
•
Remove the fastener (arrow) securing the silenc-
er to the rear frame.
•
Separate the right-hand silencer with balance
pipe from the left-hand silencer and at the same
time lift it clear of bracket (1).
•
If necessary, remove fasteners (2) and remove
silencer guard (3).
•
Installation is the reverse of the removal proce-
dure.
Removing and installing
18 11 301
left-hand silencer
– Remove right-hand silencer.
•
Remove the fastener securing the silencer to the
rear frame.
•
Loosen clamp (6) for silencer.
•
Separate the left-hand silencer with connecting
pipe from the exhaust manifold and at the same
time lift it clear of bracket (7).
•
If applicable, remove silencer guard (4) and
guard (5) for catalytic converter.
2
7
6
•
Installation is the reverse of the removal proce-
dure, pay particular attention to the following.
8
•
Make sure that the installed position (arrow) of
the clamp for silencer (8) is correct.
X
Tightening torques:
Guard to silencer ........................................... 9 Nm
Clamp for silencer ........................................ 55 Nm
Silencer to rear frame................................... 21 Nm
3
4
5
E180030
E180020
18.5