Inspecting front and rear wheel
bearings, replacing if necessary
(Inspection III)
L
Note:
Check play when bearings are cold.
•
Lift front/rear wheel of the ground.
•
Tilt the front/rear wheel to and fro on the axle.
–
No play should be detected.
•
Replace the bearings if play is detected.
Checking chain, chainwheel and
chain sprocket, replacing if neces-
sary
(Inspections II and III)
–
Remove the sprocket cover.
•
Check chainwheel and chain sprocket for distor-
tion.
1
2
3
–
good (1)
–
replace (2)
–
replace (3)
e
Caution:
Always replace the chain, chainwheel and sprocket
as a set.
Checking chain tension,
27 71 005
adjusting if necessary
(Inspections I, II, III and IV)
Checking chain tension
27 71 005
–
Place the unloaded motorcycle on its main (cen-
tre) stand.
e
Caution:
Check and adjust the chain tension only when the
motorcycle is unloaded.
•
Chains stretch unevenly, so turn the rear wheel
to find the point at which chain deflection midway
along the run between chainwheel and rear
sprocket is least.
•
At this point, push the chain up as far at it will go
and measure chain deflection.
Chain deflection ............ 35...45 mm (1.38...1.77 in)
F000230
E000100
00.33