1
Removing and installing
27 71 000
chain, chainwheel and chain
sprocket
e
Caution:
Always replace the chain, chainwheel and chain
sprocket as a set.
Removing and installing chain
27 72 001
•
Remove the sprocket cover.
–
Remove rear swinging arm.
....................................................See Group 33
a
•
Lift chain off chain sprocket and remove by pull-
ing towards the rear.
•
Inspect chain takeup roller (1) and slide rail (3) for
wear and replace if necessary.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Adjust chain tension before tightening the nut on
the quick-release axle.
2
4
X
Tightening torques:
Swinging arm pivot shaft ............................ 100 Nm
Strut to swinging arm ................................... 41 Nm
Rear quick-release axle.............................. 100 Nm
Chain tensioning screws .............................. 10 Nm
Wheel cover bracket to swinging arm............. 9 Nm
27 72 009 Removing and installing chain guide
rail
•
Release fasteners (2) at top and bottom and re-
move guide rail (3).
•
Installation is in the reverse of the removal proce-
dure.
Removing and installing chain takeup roller
L
Note:
The chain takeup roller can be removed and in-
stalled without removing the chain and the rear
wheel.
•
Remove nut (4) with a/f 6 Allen key.
•
Remove chain takeup roller (1) together with the
fastener.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Chain takeup roller to frame ......................... 21 Nm
3
E270020
27.5