Removing/Installing Or Dismantling Starter Motor - BMW F 650 GS Repair Manual

•
Fit gasket.
•
Screw assembly handle, BMW No. 12 5 500,
into the central hole in the right engine cover.
•
Fit right engine housing cover and bolt together.
•
Remove assembly handle and screw in central
plug.
•
Connect the plugs of the ignition trigger and the
stator.
•
Clip the stator connector onto the plug.
•
Secure the cable cover to the engine.
X
Tightening torque:
Magnetic hub
(clean thread + Loctite 243)........................ 180 Nm
Engine cover, right ....................................... 10 Nm
Cable cover to engine .................................... 5 Nm
Removing/installing or
12 41 020
dismantling starter motor
Removing/installing starter
12 41 020
motor
e
Caution:
Disconnect the negative battery cable first, then the
positive cable.
•
Disconnect the battery.
•
Disconnect positive cable (1).
•
Remove fastener (2) from engine block and re-
move starter.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Check O-ring for damage and replace if neces-
sary.
e
Caution:
Connect the positive battery cable first, then the
negative cable.
X
Tightening torque:
Starter motor to engine block....................... 10 Nm
Positive cable to starter motor........................ 5 Nm
1
2
E120010
12.9