Brake Pedal; Checking Security Of Threaded Fasteners; (Inspections I, Ii, Iii And Iv) - BMW F 650 GS Repair Manual

Brake pedal

2
•
Remove hexagon fit bolt (2).
•
Remove bushing (1).
•
Grease the bushing and the fit bolt.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
Check operation of brake-light switch (3).
X
Tightening torques:
Brake pedal to frame .................................... 21 Nm
Lubricant:
for pivot bushing............... Staburags NBU 30 PTM
00.38
3
1
E340040
Checking security of threaded
fasteners

(Inspections I, II, III and IV)

•
Check the security of the following threaded fas-
teners:
– Engine mounting bolts and nuts
– Threaded t frame
– Main and side stands
– Exhaust mountings
– Swinging fork pivots
– Angled lever
– Brake pedal
– Quickrelease axles
X
Tightening torques:
Engine/crankcase
to main frame at rear .................................... 41 Nm
Engine/cylinder head to main frame at top ... 41 Nm
Engine/crankcase to engine mounting
at front ......................................................... 41 Nm
Engine mounting to main frame.................... 21 Nm
Footrest plate to main frame......................... 21 Nm
Engine guard to frame.................................... 9 Nm
Rear frame to main frame ............................. 21 Nm
Centre stand to main frame.......................... 41 Nm
Side stand undersection to main frame ........ 21 Nm
Exhaust manifold to cylinder head................ 20 Nm
Silencer to exhaust manifold
(Torca clamp) ............................................... 55 Nm
Silencer to rear frame................................... 21 Nm
Spring strut to angled lever .......................... 47 Nm
Angled lever to frame ................................... 41 Nm
Strut to angled lever ..................................... 71 Nm
Strut to swinging arm ................................... 41 Nm
Swinging-arm axle...................................... 100 Nm
Footbrake lever to frame .............................. 21 Nm
Clamp of front quick-release axle ................. 23 Nm
Front quick-release axle to fork leg .............. 80 Nm
Rear quick-release axle to swinging arm .... 100 Nm