BMW F 650 GS Repair Manual page 207

Removing and installing
32 71 008
handlebar
– Remove left handlebar fitting.
– Remove right handlebar fitting.
•
Remove impact pad (1).
•
Loosen clamping screws (2).
•
Remove handlebar (4) together with clamping
blocks (3).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
Note the position of the clamping blocks. Wide hole
spacing (arrow) to the front.
L
Note:
The position of the handlebar is indicated by a
punch mark (arrow) on the handlebar.
E320120
•
Begin by tightening the front securing screws (as
viewed in the forward direction of travel), then
tighten the rear securing screws.
X
Tightening torques:
Handlebar to fork bridge .............................. 21 Nm
1
2
3
4
E320110
E320130
32.9