BMW F 650 GS Repair Manual page 291

•
Remove the fastener securing the plug of the
brake-light switch (arrow) at the frame
•
Disconnect plug of brake light switch.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Brake light switch, footbrake, to frame ........... 5 Nm
Removing and installing
61 31 300
front-brake switch for brake light
– Place motorcycle on its centre stand.
– Remove seat.
– Remove left, right and centre covers.
•
Remove brake-light switch (1).
•
Cut through cable clip.
•
Disconnect the expansion tank and pull it to one
side.
•
Remove the fasteners securing the oil tank and
allow the oil tank to dangle to one side on the
hoses.
•
Remove the starter relay from the holder.
•
Remove the lid of the electronic equipment box.
•
Cut through the cable tie holding the wiring har-
ness at the electronic equipment box.
•
Disengage cover from the anchorage on main
frame on left.
E610060
•
Disconnect plug of brake light switch (2).
•
Push the cover over the cylinder head slightly to
one side and remove the connector.
X
Tightening torques:
Oil tank to intake air silencer .......................... 9 Nm
Lid of electronic equipment box ..................... 4 Nm
Expansion tank to radiator ............................. 9 Nm
Brake-light switch to handlebar fitting ............ 3 Nm
1
E610070
2
E610030
61.11