Removing and installing
62 11 200
instrument panel
–
Place motorcycle on its centre stand.
–
Remove left and right covers.
L
Note:
Note washers and rubber ring.
•
Remove the windshield.
•
Remove the instrument cover.
•
Remove the fairing upper section.
•
Disconnect the multi-pin plug from the headlight.
•
Pull off the rubber boot and pull the socket of the
sidelight to the rear.
•
Remove the fairing lower section complete with
the headlight.
2
•
Disconnect the plug for the warning lights (2).
•
Pull off the rubber boot (1) and disconnect the
plug.
•
Remove the fuses (arrows) and remove the in-
strument cluster.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
d
Warning:
After installing the windscreen, check and if neces-
sary adjust the headlight setting.
62.6
Replacing telltale/warning lights
–
Remove instrument panel.
•
Remove rubber grommet (3).
•
Pull the indicator light out of the socket.
•
Installation is the reverse of the removal proce-
dure.
1
62 11 630
assembling instrument cluster
–
Remove instrument panel.
•
Remove 3 securing screws from the transparent
instrument cover and remove the cover.
•
Remove the bezel.
E620010
•
Remove the securing screws (arrows) and re-
move the cover (4).
3
Disassembling and
4
E620040
E620020