5
4
Checking and centering
36 32 528
front and rear wheel rims
–
Remove the wheels.
Checking rims
36 32 528
–
[Rear wheel] Remove chainwheel carrier com-
plete with chainwheel from the rear-wheel hub.
–
[Rear wheel] Remove the spacer on the left.
–
Remove tyre.
•
Level the balancing unit, BMW No. 36 3 600, by
means of bubble gauge (3) in the baseplate.
•
Pass the balancing shaft, BMW No. 36 3 617,
through the wheel bearings.
•
Lightly pretension bearing with knurled nut (1).
•
Fit wheel on balancing device.
•
Use pin (2) to lock the balancing shaft against the
balancing stand to prevent the shaft from turn-
ing.
•
Push locating disc (4), BMW No. 36 3 615, on to
the balancing shaft on the opposite end, until
there is no play at the balancing shaft. Secure the
locating disc in position.
1
36 3 617
36 3 600
3
L
Note:
Apply the dial gauge, BMW No. 00 2 510, only to
the machined inner surface of the wheel rim.
•
Measure lateral and vertical runout with dial
gauge (5), BMW No. 00 2 510.
Vertical runout.......................... max. 2 mm (0.08 in)
Lateral runout........................... max. 2 mm (0.08 in)
2
F360150
36.13