•
Engage the lugs on the circlip in the recesses in
the freewheel gear.
•
Clean the threads of the securing screws and
freewheel housing, coat threads with
Loctite 648 and install the screws.
•
Check locking function and locking direction of
freewheel.
X
Tightening torques:
Machine screw
(clean threads + Loctite 648) ........................ 35 Nm
Removing clutch
21 21 000
•
Turn engine round in assembly fixture.
•
Remove left retaining for engine housing cover
and remove cover.
Removing pressure plate
2
1
•
Remove hex screws (2) in diagonally opposite
sequence.
•
Lift off complete pressure plate (1).
Removing clutch plates
e
Caution:
The topmost clutch plate is offset. Make sure this
plate is installed in the correct position.
•
Take plate cluster out of clutch cage.
11.38
•
Using locating ring, BMW No. 21 4 600, prevent
clutch cage (4) and driver (3) from moving and
unscrew hex nut.
•
Pull off driver.
•
Pull off clutch cage and ring gear.
e
Caution:
Note the backup washer at the bottom.
•
Pull off needle cages.
•
Remove the backup washer.
E110250
21 4 600
3
4
E110260