Removing and installing bat-
61 21 100
tery carrier
–
Place motorcycle on its centre stand.
–
Remove seat.
–
Remove left, right and centre covers.
–
Remove the battery.
......................................................... See above
a
–
Remove the intake air pipe.
....................................................See Group 13
a
–
Remove intake air silencer.
....................................................See Group 13
a
•
Remove the starter relay from the holder.
•
Remove the lid of the electronic equipment box.
•
Remove the fasteners for the battery tray.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Intake air silencer to retainer .......................... 9 Nm
Intake air silencer to oil tank ........................... 9 Nm
Connecting flange .......................................... 5 Nm
Fasteners, cover/
trim panel for turn indicator ............................ 3 Nm
Lid of electronic equipment box ..................... 4 Nm
Replacing fuses
Motorcycle fuses
–
Remove seat.
•
Open the cover of the fuse box.
•
Replace the defective fuse.
Fuses
2
4
1 BMS Compact ........................................... 20 A
2 Headlight, brake light, turn indicators,
horn ........................................................... 15 A
3 Fan............................................................ 7.5 A
4 Heated handlebar grips............................. 7.5 A
Removing and installing
61 13 011
electronic equipment box
–
Remove battery carrier.
......................................................... See above
a
•
Disconnect the expansion tank from the radiator,
pull it to one side and allow it to dangle from the
hose.
•
Remove the fasteners securing the oil tank and
allow the oil tank to dangle to one side on the
hoses.
•
Remove circlip securing throttle cable to throttle
flap stub and disengage the throttle cable from
the guide.
•
Disengage throttle cable from adapter.
•
Pull the throttle cable forward to remove.
•
Disengage the cover from the anchorages on the
main frame on each side and remove.
•
Remove screws securing ignition coil to cylinder
head cover.
•
Cut through the cable tie holding the wiring har-
ness at the electronic equipment box.
•
Remove the relay panel from the electronic
equipment box.
•
Cut through the cable tie holding the wiring har-
ness at the electronic equipment box.
•
Remove the fastener securing the electronic
equipment box to the frame.
•
Pull the electronic equipment box toward the
rear and off the pin on the frame.
•
Turn the electronic equipment box and remove it
toward the rear.
•
Installation is the reverse of the removal proce-
dure.
1
3
E610100
61.9