e
Caution:
Do not raise the rear frame all the way, as it would
contact the lock of the seat (arrow).
•
Raise the rear frame far enough to expose the
eye of the spring strut and secure the rear frame
in this position with the strap.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
When lowering the rear frame, make sure that the
brake line is routed between the front section of the
mudguard and the rear frame.
•
Clean the threads of the frame and the securing
screws for the rear frame, coat threads with
Loctite 2701 and install the screws.
X
Tightening torques:
Rear frame to main frame, top ...................... 21 Nm
Rear frame to main frame, bottom
(clean threads + Loctite 2701) ...................... 21 Nm
Brake fluid reservoir to rear frame .................. 5 Nm
Clamp for silencer ........................................ 55 Nm
Oxygen sensor to exhaust............................ 45 Nm
Exhaust manifold to cylinder head................ 20 Nm
Engine guard to frame .................................... 9 Nm
46.8
Removing and installing front
46 61 000
mudguard
–
Place the motorcycle on its centre stand.
E330070
•
Remove fasteners securing front mudguard (1).
•
Remove front mudguard.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Clean the threads of the fork bridge and the se-
curing screw of the front mudguard, coat threads
with Loctite 243.
X
Tightening torques:
Front mudguard to fork bridge
(clean threads + Loctite 243).......................... 3 Nm
Removing and installing rear
46 51 050
frame
–
Place the motorcycle on its main (centre) stand.
–
Secure front wheel in position.
–
Remove the seat.
–
Remove exhaust manifold.
....................................................See Group 18
a
•
Remove the fuse box.
•
Remove brake fluid reservoir from rear frame.
1
E460041