Changing oil in telescopic
00 11 279
forks
(Inspection III)
–
Place motorcycle on its centre stand.
–
Lift front wheel clear of the ground.
•
Remove the sealing caps from the fork legs.
•
Slacken clamp screws (1, 2) at top/bottom fork
bridges.
4
•
Pull the fork legs up and tighten the clamp
screws.
d
Warning:
Note that plugs (4) at left and right are spring-load-
ed. Wear protective goggles when removing and in-
stalling.
•
Press plug (4) down and remove snap ring (3).
Carefully allow the plug to ride up and remove.
00.20
1
2
•
Position a drip tray beneath the telescopic forks.
•
Slacken oil drain plugs (5) on left and right.
•
Allow all the oil to drain off.
e
Caution:
Dispose of used oil in an environmentally compati-
E310030
ble manner.
•
Install the oil drain plugs (5) with new sealing
rings and tighten.
•
Fill with specified quantity of oil.
•
Install plugs in left and right forks, complete with
snap rings.
•
Slacken clamp screws (1, 2) at top/bottom fork
bridges and lower the fork legs.
•
Tighten clamp screws at top and bottom fork
bridges.
•
Install the sealing caps.
3
Oil content of each fixed fork tube
................... 0.60 l (1.06 Imp. pints/0.62 US quarts)
Operating fluids:
Telescopic fork................... BMW telescopic fork oil
E310010
X
Oil drain plug.................................................. 6 Nm
Clamp screws,
top/bottom fork bridges ............................... 21 Nm
Tightening torques:
5
E310020