Removing and installing
61 33 000
horn
–
Remove front mudguard.
....................................................See Group 46
a
2
1
•
Disconnect plug for horn (2).
•
Remove fastener securing horn (1).
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Horn to bottom fork bridge ........................... 18 Nm
Lid of electronic equipment box ..................... 4 Nm
Front mudguard to fork bridge........................ 3 Nm
Removing and installing
61 31 227
idle-indicator switch
–
Remove cover for chain drive sprocket.
3
•
Remove fastener securing cable to idle-indicator
switch.
•
Remove idle switch (3).
61.12
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Clean the threads of the idle-indicator switch and
coat with Loctite 243.
X
Tightening torques:
Idle-indictor switch
(clean thread + Loctite 243)............................ 3 Nm
Removing and installing front and
rear ABS sensors
See Group 34
E610080
E610090