Removing And Installing Coolant-Temperature Sensor - BMW F 650 GS Repair Manual

X
Tightening torques:
Intake air silencer to retainer .......................... 9 Nm
Intake air silencer to oil tank ........................... 9 Nm
Connecting flange .......................................... 5 Nm
Fasteners, cover/
trim panel for turn indicator ............................ 3 Nm
Lid of electronic equipment box ..................... 4 Nm
Electronic equipment box to frame................. 5 Nm
Expansion tank to radiator.............................. 9 Nm
Ignition coil to cylinder head........................... 9 Nm
Removing and installing
61 31 906
coolant-temperature sensor
See Group 17
Removing and installing side
61 31 302
stand switch
– Place motorcycle on its centre stand.
– Remove the engine guard.
•
Disconnect side-stand switch plug (1) and unclip
the plug.
•
Disconnect plug of oxygen sensor.
•
Remove lower section.
61.10
•
•
•
•
•
X
Lower section to engine shell....................... 21 Nm
Lower section to main frame ........................ 21 Nm
Engine guard to frame.................................... 9 Nm
1
61 31 310
rear-brake switch for brake light
–
–
E610050
•
•
•
3
Cut the cable ties at the lower section (arrows).
Remove retaining ring (2).
Lift switch (3).
Disconnect plug of switch (3).
Installation is the reverse of the removal proce-
dure.
Tightening torques:
Removing and installing
Remove seat.
Remove right cover.
4
Remove brake-light switch (4).
Cut through the cable tie at the frame.
Remove the fuse box.
2
E610040
E340040