Removing Coolant Pump - BMW F 650 GS Repair Manual

12
11
10
Removing and installing
11 51 025
coolant pump

Removing coolant pump

11 51 025
– Remove seat.
– Remove left cover.
....................................................See Group 46
a
– Drain engine oil.
....................................................See Group 00
a
– Place motorcycle on side stand.
– Position a drip tray beneath the engine.
•
Remove drain plug (1) from water pump.
•
Hold a funnel below the drain and open the radi-
ator cap.
•
Drain off all the coolant.
– Place motorcycle on its centre stand.
•
Remove the gear shift pedal.
– Remove the starter motor.
....................................................See Group 12
a
•
Disconnect clutch cable at releaser shaft.
•
Disconnect the oil return line from the engine and
the oil tank.
•
Disconnect the oil line from the cylinder head.
8
7
6
3
•
Using hose clip pliers, BMW No. 17 5 500, re-
move hose clips (13).
•
Remove water pump cover (2) with seal (3).
•
Drive out pin (5) and remove impeller (4).
•
Remove left engine cover (9).
•
Press out sealing rings (7, 8).
•
Remove shaft (6) by pulling inwards.
•
Remove washer (10), pin (11) and gear (12).
9
5
4
2
1
E170070
13
E170060
17.7