Removing and installing
51 25 040
ignition switch/steering lock
–
Place motorcycle on its centre stand.
e
Caution:
Cover or mask off the instrument cluster and trim to
prevent scratches.
1
2
•
Remove impact pad (2).
•
Remove clamp blocks (1).
•
Remove the handlebar and place it in front of the
instrument cluster.
3
4
•
Unscrew hex nut (5).
•
Release clamping screws (3) at upper fork
bridge.
•
Unclip the clutch cable and the brake hose from
their holders.
•
Cut through the 2 cable ties at the left of the
frame head.
•
Cut through the 2 cable ties at the left of the
frame head.
•
Remove the fasteners securing the oil tank and
allow the oil tank to dangle to one side on the
hoses.
•
Remove the starter relay from the holder.
•
Remove the lid of the electronic equipment box.
•
Cut through the cable tie holding the wiring har-
ness at the electronic equipment box.
•
Disengage cover from the anchorage on main
frame on left.
E320010
•
Disconnect plug for ignition lock (6).
•
Remove the cable complete with the plug.
•
Remove the upper fork bridge complete with the
ignition lock.
10
8 9
5
E320020
•
Remove securing screws (7) and remove ignition
switch (10).
•
Using a 5 mm (0.20 in) bit, drill at least 6 mm
(0.24 in) into the non-removable screws (9).
•
Using an 8 mm (0.31 in) bit, drill at least 5 mm
(0.20 in) into the non-removable screws.
•
Break off the heads of the non-removable
screws.
•
Remove the ignition lock (8) from the fork bridge.
6
E610030
8
7
E510010
51.5