Removing camshafts
11 31 022
•
Remove the cable cover from the right-hand side
of the cylinder.
•
Remove the retainer of the spring-strut adjusting
knob from the frame.
•
Disconnect plug of oil-pressure switch.
–
Raise the rear frame.
....................................................See Group 46
a
•
Disconnect the oil feed line (arrow) from the en-
gine.
•
Disconnect the oil feed hose from the oil tank.
•
Remove the oil feed line from the ABS modulator
frame and push it to the right.
•
Remove the chain tensioner.
2
1
3
•
Remove chain guide (1).
•
Remove upper section of camshaft carrier (2).
•
Remove camshafts with chain sprockets.
•
Secure timing chain with retaining wire.
•
Remove front chain guide rail (3).
11.18
Removing cylinder head
11 12 116
•
Remove lower section of camshaft carrier.
•
Remove screws securing cylinder head to
frame (arrow).
•
Use pin wrench, BMW No. 11 6 661, to slacken
the locknut.
E110470
L
Note:
Note washers.
•
Back off the adjuster sleeves.
5
E110420
•
Disconnect the coolant hose from cylinder
head (4) and drain the last of the coolant from the
radiator.
•
Disconnect the plug for temperature sensor (5).
E110480
4
E110490