•
Lay the engine on its left side, as viewed in the
forward direction of travel.
•
Secure engine adapter, BMW No. 11 0 640, to
the right side of the engine without a spacer.
•
Position the assembly stand beside the lifting
platform.
•
Manoeuvre the engine so that the engine adapter
is level with the flange of the assembly stand.
1
•
Secure engine adapter (1) to the flange of the as-
sembly stand (2).
•
Turn engine adapter.
3
2
Lowering engine
11 00 050
Preparatory work
11 00 050
–
Drain coolant.
....................................................See Group 00
a
–
Place motorcycle on its centre stand.
E110060
–
Secure front wheel in position.
–
Remove seat.
–
Remove intake air silencer.
....................................................See Group 13
a
•
Disconnect battery negative terminal.
–
Remove engine guard.
–
Drain engine oil.
....................................................See Group 00
a
–
Remove rear wheel.
....................................................See Group 36
a
–
Remove exhaust manifold.
....................................................See Group 18
a
•
Disconnect oil feed and return lines from oil tank.
•
Remove cable cover (3) from the engine.
•
Cut the cable tie (arrow) at the voltage regulator.
•
Disconnect the plug of the voltage regulator.
•
Remove voltage regulator (6).
•
Straighten tab (4) and release breather line (5).
L
Note:
The chain drive sprocket has to be removed at this
point before engine disassembly can proceed.
•
Remove the chain sprocket.
....................................................See Group 27
a
•
Remove ground terminal (1) from the engine.
1
4
2
E110020
3
4
5
6
E110010
11.23