BMW F 650 GS Repair Manual page 213

Removing and installing left and
right handlebar levers
Removing and installing left
32 72 070
handlebar lever
•
Disengage clutch cable (1) from release lever.
•
Pull cable out of holder (2).
•
Remove the rubber grommet from the clutch le-
ver.
3
•
Make sure that slots in adjusting screw, locknut
and lever fitting (arrow) are in line.
•
Pull back cable shroud (3).
•
Pull the cable forward through the slot and disen-
gage the nipple.
•
Slacken the locknut at the handlebar lever
•
Slacken the pivot pin of the clutch lever.
•
Installation is the reverse of the removal proce-
dure.
1
2
E320150
E320160
4
5
•
After installing the cable, adjust clutch clearance
by setting distance "B" by turning adjusting
screw (4) on the clutch handlebar fitting.
•
Lock adjusting screw (4) with knurled nut (5).
Dimension "B" ............. 1.0...2.0 mm (0.04...0.08 in)
X
Tightening torques:
Locknut ......................................................... 5 Nm
Pivot pin of clutch lever .................................. 3 Nm
Removing and installing right
32 72 119
handlebar lever
•
Slacken the locknut at the handlebar lever.
•
Slacken the pivot pin of the handbrake lever.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
X
Tightening torques:
Locknut of handbrake lever ............................ 7 Nm
Pivot pin of handbrake lever ........................... 7 Nm
B
E000200
32.15