Replacing Oil Filter Element; Filling With Engine Oil - BMW F 650 GS Repair Manual

Replacing oil filter element

00 11 215
1
3
•
Remove the left-hand screw (3) securing the oil-
filter cover (1).
•
Remove the cable for the neutral indicating
switch from its guide.
•
Engage the oil drain guide, BMW No. 11 7 511,
on the pins (arrows) on the engine block.
•
Position a drip tray beneath the engine.
•
Remove the screws (2) and remove the oil-filter
cover.
•
Remove the filter element.
•
Fully drain the oil and clean the oil-filter housing.
e
Caution:
Dispose of the used oil and oil filter in an environ-
mentally compatible manner.
•
Fit a new filter element onto the oil-filter cover.
•
Coat the O-ring of the new filter element lightly
with oil.
•
Check the O-ring of the oil-filter cover for dam-
age and replace if necessary.
•
Install the oil-filter cover complete with filter ele-
ment.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Do not reinstall the engine guard, cover and chain
sprocket cover at this stage, if other maintenance
work has to be performed on assemblies normally
concealed by these components.
X
Tightening torques:
Oil filter cover ............................................... 10 Nm
Cover for chain sprocket ................................ 2 Nm
2
11 7 511
E000190

Filling with engine oil

00 11 215
•
Install the oil drain plug in the oil tank with a new
sealing ring and tighten.
•
Install the oil drain plug in the engine with a new
sealing ring and tighten.
•
Fill the oil tank with 2 l (3.5 Imp. pints/2.1 US
quarts) of engine oil and install the filler cap.
d
Warning:
Observe the hazard avoidance instructions for run-
ning internal combustion engines in enclosed spac-
es.
•
Run the engine for thirty seconds.
•
Add another 0.3 l (0.53 Imp. pints/0.32 US
quarts) of engine oil to the oil tank.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
Make sure that when the engine is at operating tem-
perature, the oil level is not above the specified
level (arrow).
•
Check the oil level with the engine at operating
temperature and top up if necessary.
Operating fluids:
Brand-name HD oil, API classification SF, SG or SH;
suffix letters CD or CE are permitted; alternatively,
brand-name HD oil of CCMC classification G4 or
G5; suffix PD2 is permitted.
Engine oil capacity:
For filter
change.......... 2.3 l (4.05 Imp. pints/2.43 US quarts)
X
Tightening torques:
Oil tank drain plug ........................................ 21 Nm
Engine oil drain plug..................................... 40 Nm
Engine guard to frame.................................... 9 Nm
E000010
00.17