Installing magnetic ignition
12 11 070
trigger
e
Caution:
Tapers on crankshaft and magnet hub and hex nut
must be clean and free of grease.
•
Apply a thin coat of Loctite 648 to the magnet
hub taper.
•
Oil freewheel in freewheel housing.
1
•
Slide magnet wheel (1) onto crankshaft: woodruff
key and keyway must be aligned.
•
Rotate starter double gear (2) counter-clockwise
to enable the freewheel to slide on to the collar of
the freewheel gear.
•
Clean the threads on the crankshaft and the
threads of the nut.
•
Install snap ring and coat threads of hex nut with
Loctite 243 and tighten.
11.50
2
E110370
•
Coat the rubber grommet (3) of the transmitter
and the rubber grommet of the stator cable with
3 Bond 1209 and install in cover of engine block.
•
Fit gasket.
•
Screw assembly handle, BMW No. 12 5 500,
into the central hole in the right engine cover.
•
Fit right engine housing cover and bolt together.
•
Remove assembly handle and screw in cover.
X
Tightening torque:
Magnetic hub
(clean thread + Loctite 243)........................ 180 Nm
Engine cover, right ....................................... 10 Nm
3
E110380