Antifreeze
Use only nitrite-free long-term antifreeze and corro-
sion inhibitor.
Concentration
Antifreeze .........................................................50%
Water ...............................................................50%
•
Run the engine for a short time, then switch it off.
•
Check coolant level and top up if necessary.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Do not reinstall the cover at this stage, if other main-
tenance work has to be performed.
X
Tightening torques:
Drain plug..................................................... 10 Nm
Expansion tank to radiator.............................. 9 Nm
Bleed screw ................................................. 12 Nm
Removing and installing
coolant-temperature sensor
–
Drain coolant.
....................................................See Group 00
a
•
Place motorcycle on its centre stand.
1
•
Remove plug from coolant temperature
sensor (1).
•
Remove coolant-temperature sensor (2).
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torque:
Temperature sensor ..................................... 15 Nm
2
E170050
17.9