Replacing Spark Plug; Replacing Ignition Lead; Remove The Intake Air Silencer Together With The Intake Air Pipe; Removing/Installing Coil - BMW F 650 GS Repair Manual

Replacing spark plug

12 12 011
See Group 00

Replacing ignition lead

12 12 085
– Remove left, right and centre covers.
– Remove the battery.
Remove the intake air silencer together with the
intake air pipe.
•
Remove the fastener for the intake air silencer
from the oil tank.
•
Remove the fasteners for the intake air silencer
from the retainer.
•
Remove the starter relay from the holder.
•
Slacken the fasteners for the lid of the electronic
equipment box.
•
Remove the fasteners for the battery tray.
•
Disengage the clamp securing the breather hose
and disconnect the hose from the intake air si-
lencer.
•
Press the oil tank slightly to the left and carefully
disconnect the intake air silencer from the throt-
tle flap stub.
•
Pull the intake air silencer with intake air pipe and
battery carrier to the rear to remove.
•
Cover/seal the throttle flap stub.
•
Disconnect the ignition lead from the ignition coil
and the spark plug and remove.
X
Tightening torque:
Lid of electronic equipment box. .................... 4 Nm
Oil tank to intake air silencer .......................... 9 Nm
Intake air silencer to frame ............................. 9 Nm
Trim panel/cover ............................................ 3 Nm

Removing/installing coil

12 13 000
– Remove left, right and centre covers.
– Remove the battery.
Remove the intake air silencer together with the
intake air pipe.
•
Remove the fastener for the intake air silencer
from the oil tank.
•
Remove the fasteners for the intake air silencer
from the retainer.
•
Remove the starter relay from the holder.
•
Slacken the fasteners for the lid of the electronic
equipment box.
•
Remove the fasteners for the battery tray.
•
Disengage the clamp securing the breather hose
and disconnect the hose from the intake air si-
lencer.
•
Press the oil tank slightly to the left and carefully
disconnect the intake air silencer from the throt-
tle flap stub.
•
Pull the intake air silencer with intake air pipe and
battery carrier to the rear to remove.
•
Cover/seal the throttle flap stub.
3
4
•
Disengage cover (1) from the anchorages on
main frame on each side and remove.
•
Disconnect starter coil (2) at plug.
•
Pull spark plug connector (4) off spark plug.
•
Remove screws securing ignition coil (3) to cylin-
der head cover.
X
Tightening torques:
Ignition coil to cylinder head........................... 9 Nm
Lid of electronic equipment box ..................... 4 Nm
Oil tank to intake air silencer .......................... 9 Nm
Intake air silencer to frame ............................. 9 Nm
Trim panel/cover ............................................ 3 Nm
1
2
E000030
12.11