2
1
8
7
6
Removing and installing cockpit fairing
–
Remove left and right covers.
......................................................... See above
a
L
Note:
Note washers and rubber ring.
•
Remove windscreen (1).
•
Remove the fasteners securing the cockpit
fairing (2).
•
Disconnect multi-pin plug (5).
•
Pull the rubber boot to the rear.
•
Pull the socket of the sidelight out of the head-
light housing.
•
Remove the fairing lower section complete with
headlight (8).
•
Remove instrument cover (3).
•
Remove fairing upper section (4).
–
Remove front mudguard.
......................................................... See below
a
•
Disconnect plug for horn (7).
•
Remove cover (6).
46.6
4
5
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
d
Warning:
After installing the windscreen, check and if neces-
sary adjust the headlight setting.
X
Tightening torques:
Windscreen fasteners..................................... 2 Nm
46 63 198 Removing and installing fairing
bracket
–
Remove instrument panel.
....................................................See Group 62
a
•
Unclip plug for turn indicators.
•
[ABS] Disconnect front ABS sensor plug and un-
clip the plug.
3
E460050