Configuring Vlan Interfaces; Interface Vlan; Table 34-4 Commands For Configuring Vlan Interfaces - SMC Networks TigerStack II SMC8926EM Management Manual

Example
The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN
is activated by default.
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Related Commands
show vlan (34-13)

Configuring VLAN Interfaces

Table 34-4 Commands for Configuring VLAN Interfaces

Command

interface vlan

switchport mode
switchport
acceptable-frame-types
switchport ingress-filtering
switchport native vlan
switchport allowed vlan
switchport gvrp
switchport forbidden vlan
switchport priority default
interface vlan
This command enters interface configuration mode for VLANs, which is used to
configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
Function
Enters interface configuration mode for a specified VLAN
Configures VLAN membership mode for an interface
Configures frame types to be accepted by an interface
Enables ingress filtering on an interface
Configures the PVID (native VLAN) of an interface
Configures the VLANs associated with an interface
Enables GVRP for an interface
Configures forbidden VLANs for an interface
Sets a port priority for incoming untagged frames
Configuring VLAN Interfaces
34
Mode Page
IC 34-7
IC 34-8
IC 34-9
IC 34-9
IC 34-10
IC 34-11
IC 34-3
IC 34-12
IC 35-3
34-7