Show Interfaces Switchport; Table 27-2 Show Interfaces Switchport - Display Description - SMC Networks TigerStack II SMC8926EM Management Manual

show interfaces switchport

This command displays the administrative and operational status of the specified
interfaces.
Syntax
show interfaces switchport [interface]
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
• port-channel channel-id (Range: 1-32)
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 4.
Console#show interfaces switchport ethernet 1/4
Broadcast Threshold
LACP Status
Ingress Rate Limit
Egress Rate Limit
VLAN Membership Mode
Ingress Rule
Acceptable Frame Type
Native VLAN
Priority for Untagged Traffic : 0
GVRP Status
Allowed VLAN
Forbidden VLAN
802.1Q-tunnel Status:
802.1Q-tunnel Mode:
802.1Q-tunnel TPID:
Console#

Table 27-2 show interfaces switchport - display description

Field
Broadcast Threshold
LACP Status
Ingress/Egress Rate Limit
VLAN Membership Mode
: Enabled, 500 packets/second
: Disabled
: Disable, 1000M bits per second
: Disable, 1000M bits per second
: Hybrid
: Disabled
: All frames
: 1
: Disabled
: 1(u),
:
Disable
NORMAL
8100(Hex)
Description
Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 27-7).
Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 28-3).
Shows if rate limiting is enabled, and the current rate limit (page 30-1).
Indicates membership mode as Trunk or Hybrid (page 34-8).
show interfaces switchport
27
27-11