Switchport Forbidden Vlan; Displaying Vlan Information; Table 34-5 Commands For Displaying Vlan Information - SMC Networks TigerStack II SMC8926EM Management Manual

34
VLAN Commands

switchport forbidden vlan

This command configures forbidden VLANs. Use the no form to remove the list of
forbidden VLANs.
Syntax
switchport forbidden vlan {add vlan-list | remove vlan-list}
no switchport forbidden vlan
• add vlan-list - List of VLAN identifiers to add.
• remove vlan-list - List of VLAN identifiers to remove.
• vlan-list - Separate nonconsecutive VLAN identifiers with a comma and no
spaces; use a hyphen to designate a range of IDs. Do not enter leading
zeros. (Range: 1-4093).
Default Setting
No VLANs are included in the forbidden list.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command prevents a VLAN from being automatically added to the
specified interface via GVRP.
• If a VLAN has been added to the set of allowed VLANs for an interface, then
you cannot add it to the set of forbidden VLANs for that same interface.
Example
The following example shows how to prevent port 1 from being added to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport forbidden vlan add 3
Console(config-if)#

Displaying VLAN Information

This section describes commands used to display VLAN information.

Table 34-5 Commands for Displaying VLAN Information

Command
show vlan
show interfaces status vlan Displays status for the specified VLAN interface
show interfaces switchport
34-12
Function
Shows VLAN information
Displays the administrative and operational status of an
interface
Mode Page
NE, PE 34-13
NE, PE 27-9
NE, PE 27-11