Default-Router; Domain-Name - SMC Networks TigerStack II SMC8926EM Management Manual

39
DHCP Commands

default-router

This command specifies default routers for a DHCP pool. Use the no form to
remove the default routers.
Syntax
default-router address1 [address2]
no default-router
• address1 - Specifies the IP address of the primary router.
• address2 - Specifies the IP address of an alternate router.
Default Setting
None
Command Mode
DHCP Pool Configuration
Usage Guidelines
The IP address of the router should be on the same subnet as the client. You
can specify up to two routers. Routers are listed in order of preference
(starting with address1 as the most preferred router).
Example
Console(config-dhcp)#default-router 10.1.0.54 10.1.0.64
Console(config-dhcp)#

domain-name

This command specifies the domain name for a DHCP client. Use the no form to
remove the domain name.
Syntax
domain-name domain
no domain-name
domain - Specifies the domain name of the client.
(Range: 1-128 characters)
Default Setting
None
Command Mode
DHCP Pool Configuration
Example
Console(config-dhcp)#domain-name sample.com
Console(config-dhcp)#
39-8