Logging Sendmail Level; Logging Sendmail Source-Email - SMC Networks TigerStack II SMC8926EM Management Manual

• To send email alerts, the switch first opens a connection, sends all the email
alerts waiting in the queue one by one, and finally closes the connection.
• To open a connection, the switch first selects the server that successfully sent
mail during the last connection, or the first server configured by this command.
If it fails to send mail, the switch selects the next server in the list and tries to
send mail again. If it still fails, the system will repeat the process at a periodic
interval. (A trap will be triggered if the switch cannot successfully open a
connection.)
Example
Console(config)#logging sendmail host 192.168.1.19
Console(config)#

logging sendmail level

This command sets the severity threshold used to trigger alert messages.
Syntax
logging sendmail level level
level - One of the system message levels (page 23-27). Messages sent
include the selected level down to level 0. (Range: 0-7; Default: 7)
Default Setting
Level 7
Command Mode
Global Configuration
Command Usage
The specified level indicates an event threshold. All events at this level or
higher will be sent to the configured email recipients. (For example, using
Level 7 will report all events from level 7 to level 0.)
Example
This example will send email alerts for system errors from level 3 through 0.
Console(config)#logging sendmail level 3
Console(config)#

logging sendmail source-email

This command sets the email address used for the "From" field in alert messages.
Syntax
logging sendmail source-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
SMTP Alert Commands
23
23-33