Radius Client; Table 25-5 Radius Client Commands - SMC Networks TigerStack II SMC8926EM Management Manual

25
User Authentication Commands

RADIUS Client

Remote Authentication Dial-in User Service (RADIUS) is a logon authentication
protocol that uses software running on a central server to control access to
RADIUS-aware devices on the network. An authentication server contains a
database of multiple user name/password pairs with associated privilege levels for
each user or group that require management access to a switch.
Command
radius-server host
radius-server port
radius-server key
radius-server retransmit
radius-server timeout
show radius-server
radius-server host
This command specifies primary and backup RADIUS servers and authentication
parameters that apply to each server. Use the no form to restore the default values.
Syntax
[no] radius-server index host host_ip_address [auth-port auth_port] [key
key] [retransmit retransmit] [timeout timeout]
• index - Allows you to specify up to five servers. These servers are queried
in sequence until a server responds or the retransmit period expires.
• host_ip_address - IP address of server.
• auth_port - RADIUS server UDP port used for authentication messages.
(Range: 1-65535)
• key - Encryption key used to authenticate logon access for client. Do not
use blank spaces in the string. (Maximum length: 48 characters)
• retransmit - Number of times the switch will try to authenticate logon access
via the RADIUS server. (Range: 1-30)
• timeout - Number of seconds the switch waits for a reply before resending
a request. (Range: 1-65535)
Default Setting
• auth-port - 1812
• timeout - 5 seconds
• retransmit - 2
Command Mode
Global Configuration
25-6

Table 25-5 RADIUS Client Commands

Function
Specifies the RADIUS server
Sets the RADIUS server network port
Sets the RADIUS encryption key
Sets the number of retries
Sets the interval between sending authentication requests GC
Shows the current RADIUS settings
Mode Page
GC 25-6
GC 25-7
GC 25-7
GC 25-8
25-8
PE 25-8