Setting Passwords; Setting An Ip Address - SMC Networks TigerStack II SMC8926EM Management Manual

4. The session is opened and the CLI displays the "Console#" prompt indicating
you have access at the Privileged Exec level.

Setting Passwords

Note: If this is your first time to log into the CLI program, you should define new
passwords for both default user names using the "username" command, record
them and put them in a safe place.
Passwords can consist of up to 8 alphanumeric characters and are case sensitive.
To prevent unauthorized access to the switch, set the passwords as follows:
1. Open the console interface with the default user name and password "admin" to
access the Privileged Exec level.
2. Type "configure" and press <Enter>.
3. Type "username guest password 0 password," for the Normal Exec level, where
password is your new password. Press <Enter>.
4. Type "username admin password 0 password," for the Privileged Exec level,
where password is your new password. Press <Enter>.
Note: '0' specifies a password in plain text, '7' specifies a password in encrypted form.
Username: admin
Password:
CLI session with the SMC TigerStack II 10/100/1000 SMC8926EM/
SMC8950EM is opened.
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#

Setting an IP Address

You must establish IP address information for the stack to obtain management
access through the network. This can be done in either of the following ways:
Manual — You have to input the information, including IP address and subnet mask.
If your management station is not in the same IP subnet as the stack's master unit,
you will also need to specify the default gateway router.
Dynamic — The switch sends IP configuration requests to BOOTP or DHCP
address allocation servers on the network.
Basic Configuration
22-2
25-2
2
2-7