Show Ip Traffic; Routing Information Protocol (Rip); Table 42-5 Routing Information Protocol Commands - SMC Networks TigerStack II SMC8926EM Management Manual

show ip traffic

This command displays statistics for IP, ICMP, UDP, TCP and ARP protocols.
Command Mode
Privileged Exec
Command Usage
For a description of the information shown by this command, see "Displaying
Statistics for IP Protocols" on page 19-16.
Example
Console#show ip traffic
IP statistics:
Rcvd: 5 total, 5 local destination
0 checksum errors
0 unknown protocol, 0 not a gateway
Frags: 0 reassembled, 0 timeouts
0 fragmented, 0 couldn't fragment
Sent: 9 generated
0 no route
ICMP statistics:
Rcvd: 0 checksum errors, 0 redirects, 0 unreachable, 0 echo
5 echo reply, 0 mask requests, 0 mask replies, 0 quench
0 parameter, 0 timestamp
Sent: 0 redirects, 0 unreachable, 0 echo, 0 echo reply
0 mask requests, 0 mask replies, 0 quench, 0 timestamp
0 time exceeded, 0 parameter problem
UDP statistics:
Rcvd: 0 total, 0 checksum errors, 0 no port
Sent: 0 total
TCP statistics:
Rcvd: 0 total, 0 checksum errors
Sent: 0 total
ARP statistics:
Rcvd: 0 requests, 1 replies
Sent: 1 requests, 0 replies
Console#

Routing Information Protocol (RIP)

This section describes commands used to configure RIP global and interface
parameters for dynamic routing on the switch.

Table 42-5 Routing Information Protocol Commands

Command
router rip
default-metric
timers basic
network
neighbor
Function
Enables the RIP routing protocol
Sets the default metric assigned to external routes imported from
other protocols
Sets basic timers, including update, timeout, garbage collection RC
Specifies the network interfaces that are to use RIP routing
Defines a neighboring router with which to exchange information RC
Routing Information Protocol (RIP)
42
Mode Page
GC 42-6
RC 42-7
42-8
RC 42-9
42-9
42-5