Spanning-Tree Transmission-Limit; Spanning-Tree Mst-Configuration - SMC Networks TigerStack II SMC8926EM Management Manual

Command Usage
The path cost method is used to determine the best path between devices.
Therefore, lower values should be assigned to ports attached to faster media,
and higher values assigned to ports with slower media. Note that path cost
(page 33-12) takes precedence over port priority (page 33-13).
Example
Console(config)#spanning-tree pathcost method long
Console(config)#

spanning-tree transmission-limit

This command configures the minimum interval between the transmission of
consecutive RSTP/MSTP BPDUs. Use the no form to restore the default.
Syntax
spanning-tree transmission-limit count
no spanning-tree transmission-limit
count - The transmission limit in seconds. (Range: 1-10)
Default Setting
3
Command Mode
Global Configuration
Command Usage
This command limits the maximum transmission rate for BPDUs.
Example
Console(config)#spanning-tree transmission-limit 4
Console(config)#

spanning-tree mst-configuration

This command changes to Multiple Spanning Tree (MST) configuration mode.
Default Setting
• No VLANs are mapped to any MST instance.
• The region name is set the switch's MAC address.
Command Mode
Global Configuration
Example
Console(config)#spanning-tree mst-configuration
Console(config-mstp)#
spanning-tree transmission-limit
33
33-7