Receiving And Sending Connected Name; Network Name Display Interactions - Nortel ICS Install Manual

Receiving and Sending Connected Name

Outgoing calls record the Connected Name of outgoing calls.
The Connected Name is stored and displayed on the system
telephone. In order for this to work, you need to set the
Called ID to Yes. See Called ID on page 359.
The system also supports sending the Connected Name with
an outgoing call, which is the Business and Set Names
concatenated together, with incoming calls. You can have the
system block this display for specific PRI lines by setting the
Send Name Display heading to N. Refer to Send Name Display
(PRI) on page 525.
If the call is answered by a hunt group, the hunt group name is
used instead of the set name.
The Connected Name is a transient display that appears for
about three seconds.

Network Name Display interactions

Calling and Connected Name information (if available) is
passed between trunks with Selective Line Redirection (SLR).
Only Calling Name information is passed between trunks in
cases where Direct System Inward Access (DISA) has resulted
in tandeming of trunks.
N0130943 02
System prgrming / 469
Modular ICS 7.1 Installer Guide