Moving Telephones - Nortel ICS Install Manual

Moving telephones

You can move a system telephone to a new location within the
Norstar system without losing the programmed settings.
When Set relocation is enabled in system programming,
the internal numbers, autodial settings, and personal speed dial
codes remain with the telephone when it is unplugged.
To move a telephone, simply unplug it and plug it in again at
another location. It may take up to 45 seconds for the ICS to
recognize the telephone. Automatic telephone relocation is
disabled by default.
Tips -
connecting a new telephone into the vacated jack. This allows
the moved telephone to retain the programmed settings.
If a new telephone is plugged into the vacated jack before the
old telephone is reconnected at a new location, Norstar will
give the current telephone information to the new telephone.
The old telephone will no longer be recognized by the system.
When reprogramming the internal number of a telephone, wait
one minute after Automatic Telephone Relocation.
When you relocate a telephone, the telephone must remain
installed and connected in the new location for at least three
minutes for the programming relocation to be complete.
Moving the telephone again before the three-minute period
may result in losing the programming on the telephone.
N0130943 02
Relocate the disconnected system telephone before
Moving telephones / 293
Modular ICS 7.1 Installer Guide