Startup Programming; Performing Startup - Nortel ICS Install Manual

Startup programming

After the hardware has been installed and powered up, use
Startup to initialize the system, and select the system template
that best suits your system.

Performing Startup

1. Enter the Startup access code from a programming set, by
pressing ≤••ÍÊÅÂÊË∏ which is the
same as ≤••‡°¤‡°°‡.
To be accepted, the Startup code must be entered no later
than 15 minutes after the Norstar system has been powered
up.
If 15 minutes have elapsed since you powered up the
system, turn system power off and on and wait for the
system to power up again.
2. Enter the Installer password.
The default is Ç؈ÏÈÌ which is the same as
¤flfl‹››.
N0130943 02
Startup erases programming.
Startup erases any existing programmed data,
and resets the system to factory defaults.
Tip -
Ensure that you have current backups of your
system programming and logs.
All programming is retained for three days if the power
fails or if the Norstar system is powered off. After three
days, it may be necessary to perform Startup.
Startup programming / 327
Modular ICS 7.1 Installer Guide