Entering Programming For Installers - Nortel ICS Install Manual

332 / Programming
Hardware
Maintenance
Usage metrics

Entering programming for installers

1. Enter the installer codes on a programming set by pressing
≤••Ç؈ÏÈÌ,
which is the same as ≤••¤flfl‹››.
The display shows Password:.
2. Enter the Installer password.
The default password is CONFIG (266344).
The display shows Terminals&Sets. Three triangular
indicators º appear on the vertical display between the
rows of buttons.
3. Place the programming overlay over the buttons pointed to
by the indicators º.
TIP -
However, for programming, they have different sets of
programming buttons, even though they use the same
programming overlay. Once you enter programming, the
indicators will make it clear which part of the overlay you need
to use.
Modular ICS 7.1 Installer Guide
Allows you to configure the Trunk
Cartridges and BRI cards used by the
system.
Allows you to view diagnostic
information about the system and
provision BRI cartridges.
Provides statistical information about
Hunt groups.
7316 and 7316E digital phones look very similar.
N0130943 02