Configuring Centralized Voice Mail; Local System - Nortel ICS Install Manual

Configuring centralized voice mail

System configuration for centralized voice mail depends on
where the NAM is connected. The system with the NAM is
configured using the voicemail DN and a target line. The
systems that are remote to the NAM are configured through
the Telco features sections.
Installation instructions about installing Norstar voice mail as
a centralized voice mail system, are explained in the
addendum titled: Installing Norstar Voice Mail as a
Centralized Voice Mail System. This addendum includes
details about voice mail configuration, as well as the Norstar
Modular ICS configuration that is included in the following
sections.

Local system

To set up the local system, you need to assign a target line to
the DN for the voice mail system, then enter that DN into the
target line record.
1. After you enter your password, at the Terminals&Sets
prompt, press ≠.
The prompt displays: Show set:
2. Enter the DN number for the voice mail system.
3. Press ≠. The prompt displays Line access.
4. Press ≠. The prompt displays Line
assignment.
5. Enter the target line number for your voice mail system.
6. Press CHANGE to change the setting for each line to one of
the following: Unassigned, Ring only, Appr&Ring, and
Appr only.
N0130943 02
Private networking using PRI SL-1 / 167
Modular ICS 7.1 Installer Guide